The Starter Panel has is solid state Current Meters. It measures currents and provides protection against overload for both the motors. This is based on a Micro controller, programmed for the application. The Meter’s supplied preprogrammed for operation and can be directly installed
- Nominal Input Voltage: 160 – 270 VAC, 50Hz.
- Accuracy: Current:0.25% ± 1 dgts.
- Resolution: Current:0.01 A Environmental:- 1] Working Temp : 0 to 55° C
- Storage Temp :
1. Working Temp : 0 to 55° C
2. Storage Temp : 10 to 70° C
3. Relative humidity : 0 – 95% Non-Condensing
4. Warm up time : 10 Sec
- Enclosure:
1. Mounting : Panel mounting.
2. Dimensions : 165 (W) X 60 (L) X 115 (H).
Cutout : 182(H) X 92(W) .
Enclosure: 105 (W) X 200 (L) X 193 (H) mm.
Terminal:
Working In normal running mode, display shows 1. U—Voltage
2. C—Current
3. ‹ Faults if any›
• UV—Under Voltage
• OV—Over Voltage
• OL—Over Load
• R-on AUTO—Relay on Auto
- Three digits 7 segment bright display for current.
- Parameter Setting: using front keys.
- User Programmable.
- Password protected set parameters.
- Inbuilt Single Phase 30 A Relay contact for load control.
- Message Display for faults.
- Display of Voltage and Under and Over Voltage protection
- Display of Current and Over Load and Dry Run protection
- Suitable for Auto Multi Port Valves as starter panel.
- Auto / Manual Operation
- Auto Multi Port valve power output ( in Auto Mode)
- Easy Panel mounting.
- 1 HP and 2 HP models.
