TDS Meters, Conductivity Meters For Purity Measurement, Conductivity Sensors, Mineral Content Measurement In Water Or For Other Purposes

provided with sensor

TDS / Conductivity Meter and sensor

User can select measurements either conductivity or TDS . Pressing SET key will change the controller from run mode to set mode. In the set mode user can select conductivity or TDS measurements. After the selection set menu shows setting for the same. User can change the following parameters using INC/DEC key and SET key. If conductivity/ TDS goes beyond the High alarm set point Display will show C-HI/t-HI Message. And if conductivity goes beyond the Conductivity High set point then Relay will trip. Sense time is provided for relay to trip.

  • TDS /Conductivity Range : - 0-2000ppm
  • Resolution :- 0.1ppm
  • Auxiliary Power : - 90 to 270V AC, 50 HZ
  • Relay contact ratings : - 10A/230V
  • ENCLOSURE:
  • 1] Mounting : Panel mounting.
  • 2] Position : Panel.
  • 3] Enclosure : 96(W)X96(L)X53(D)mm..
  • 4] Cut out :92(L)mm X 92(W)mm.
  • 5] Terminal : Screw ON Terminals.
  • KEYS:
  • 1. SET : This key is used to change the controller from RUN mode to FUNCTION mode for parameter setting
  • 2. INC : Up scroll the parameter & parameter value.
  • 3. DEC: Down scroll the parameter & parameter value.
  • LED INDICATIONS:
  • 1. Relay ON :Green LED
  • Glow- Relay ON
  • Not Glowing- Relay OFF
  • 2. TDS :Red LED
  • Glow- TDS Selected
  • Not Glowing- TDS not Selected
  • 3. Conductivity :Red LED
  • Glow- Conductivity Selected
  • Not Glowing- Conductivity not selected
  • Supply voltage : 230VAC ± 10% 50Hz.

 

  • Conductivity and TDS Measurement.
  • Scrolling message indications
  • Inbuilt 10A/230V relay potential free contact for high conductivity trip.
  • Four digit 7 segment bright display
  • User programmable through front keys.
  • Good stability, high reliability.

  • N/A


Download Brochure