Three Phase Pump Starter Panels, Manufacturer, Supplier, Exporter, Proton Power Control, Pune, Maharashtra, India


The dual pump starter panel is state of the art Micro Controller based. It measures Voltage and 3 phase currents of both the pumps. It has user settable Over and Under Voltage protections. It provides for settable Overload, Under-load (Dry run) and phase unbalance protections as well.
In addition phase reversal and single phase protections are also provided. It also provides for by-passing of certain protections if not desired.

  • Nominal Input Current:15 A
  • Auxillary Input Supply:415VAC +/- 10%, 50Hz, 3-Phase, 4- wire. Display: Current, Fault Messages.
  • Display Accuracy:Current : 0.25% rdg ± 1 digits.
  • Resolution: Current: 0.1 A
  • Environmenta:
    1] Working Temp : 0 to 55º C
    2] Storage Temp : 10 to 70º C
    3] Relative humidity: 0 - 95% non-condensing
    4] Warm up time : 10 Sec
  • Enclosure:
    1] Mounting : Wall mounting.
    2] Enclosure : 190 (W) X 130 (L) X 70 (H) mm.
    3] Terminal : Screw ON Terminals.


  • Designed for 3 Phase Raw Water (RWP) and High Pressure (HPP) - RO Pump Controls.
  • Three digits 7 segment bright display for current & voltage
  • Parameter Setting: using front keys.
  • User Programmable.
  • Password protected set parameters.
  • Inbuilt 3 Phase contactors 9A for RWP and 12A for HPP for load control of the pumps.
  • Message Display for faults.
  • Display of Current
  • Over Load current protection.
  • Protection for Current Unbalance between phases.
  • Auto / Manual Operation, individual pumps can be manually controlled.
  • Current protection in manual Mode as well.
  • Pumps can be configured as Single Phase.
  • Pump current protection in auto as well as manual mode.
  • Auto Multi Port valve power output ( in Auto Mode)
  • Power Output for Dosing Pump.
  • Easy Panel mounting.

  • RS485 port.

Download Brochure