Single Phase Pump Starter Panels For RO, Manufacturer, Supplier, Exporter, Proton Power Control, Pune, Maharashtra, India


The dual pump starter panel is state of the art Micro Controller based. It measures Voltage and currents of both the pumps. It has user settable Over and Under Voltage protections. It provides for settable Overload, Under-load (Dry run) and phase unbalance protections as well.
In addition phase reversal and single phase protections are also provided. It also provides for by-passing of certain protections if not desired.

  • Nominal Input Current: 30 A
  • Accuracy: Current:230VAC +/- 10% , 50Hz. Display: Voltage, Currents of both the Motors, Fault Messages.
  • Display Accuracy:Voltage : 0.25% ± 1 digits. Current : 0.25% rdg ± 1 digits.
  • Resolution:Current: 0.1 A
    Voltage : 1 V
  • Environmental:
    1] Working Temp : 0 to 55º C
    2] Storage Temp : 10 to 70º C
    3] Relative humidity: 0 - 95% non-condensing
    4] Warm up time : 10 Sec
  • Enclosure:
    1] Mounting: Panel mounting. Cut out Size: 182(H) X 92(W)
    2] Enclosure: 105 (W) X 200 (L) X 193 (H) mm.
    3] Terminal: Screw ON Terminals.


  • Designed for Single Phase Raw Water (RWP) and High Pressure (HPP) - RO Pump Controls.
  • Three digits 7 segment bright display for current & voltage
  • Parameter Setting: using front keys.
  • User Programmable.
  • Password protected set parameters.
  • Inbuilt Single Phase 30 A Relay contacts for load control of both the pumps.
  • Message Display for faults.
  • Display of Voltage and Current
  • Under and Over Voltage protection
  • Over Load current and Dry Run protection
  • Auto / Manual Operation, individual pumps can be manually controlled.
  • Voltage and Current Protection in manual mode as well.
  • Pump voltage and current protection in auto as well as manual mode.
  • Auto Multi Port valve power output ( in Auto Mode)
  • Power Output for Dosing Pump.
  • Easy Panel mounting.

  • RS485 port.

Download Brochure